OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2653

"B" Rocker Arm Actuator Control Circuit Low (Bank 1)

P2653 points to a voltage that is too low on the control line of rocker arm solenoid B, bank 1. On a solenoid switched from the supply side, a line rubbing against the engine block or a shorted coil pulls the signal down while the output is active; the controller's driver then reports an overcurrent or a low-voltage state. No manufacturer documents this code publicly. For actuator A, GM's 15OBDG05 runs the same kind of driver diagnosis on its 2015 four-cylinders above 11 V, with a fault after 100 of 120 samples and the MIL on at once. CARB treats such shorts as circuit faults that every lift system output must detect. Many drivers shut down to protect themselves, so the B stage drops out. P2650 covers an open, P2654 a short to power.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 53

Possible causes

  • Control wire of solenoid B shorted to engine ground high
  • Shorted turns inside the solenoid B coil medium
  • Engine oil inside the connector creating a leakage path low

Symptoms

  • MIL on soon after the fault appears
  • B stage switched off, reduced power or economy

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2653

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication