OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2650

"B" Rocker Arm Actuator Control Circuit/Open (Bank 1)

Some engines split rocker arm switching into two stages or groups, each fed by its own oil control solenoid; the second one is called actuator B. P2650 is logged when the engine controller finds the drive line of that B solenoid on bank 1 open, so switching the output on or off brings no matching electrical response. No carmaker publishes this code with limits. GM's 2015 four-cylinder table 15OBDG05 shows how the equivalent test for actuator A is built: a driver check that only runs above 11 V and fails after 100 bad readings out of 120. CARB requires such circuit checks for every output of a valve lift system. Shorts on the same line are reported as P2653 (ground) and P2654 (power). Until repaired, the stage served by solenoid B remains in its rest position.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 50

Possible causes

  • Open winding in the B rocker arm oil control solenoid high
  • Terminal pushed out or corroded in the solenoid B connector medium
  • Wire chafed through near the valve cover or harness clips medium
  • Failed output stage for solenoid B in the engine control module low

Symptoms

  • Check engine light on
  • Second switching stage never engages, less power or economy in that range
  • Possibly no other noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2650

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication