P264E
"A" Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic (Bank 1)
P264E covers a feedback signal from the position sensor of actuator A, bank 1, that drops out or jumps for short moments rather than staying low or high. Loose terminals, a cracked wire flexing with engine movement, or interference on an unshielded line are the usual reasons, and the fault may vanish when the vehicle is parked. CARB requires lift system inputs to be monitored for such rationality and continuity problems. No manufacturer documents P264E publicly. Because the lift controller depends on a steady reading, jumps can make it hunt or fall back to a fixed lift, which drivers notice as surging or uneven idle. Wiggle tests on the harness help locate it.
Possible causes
- Loose or spread terminal in the sensor connector high
- Wire cracked inside the insulation by engine movement medium
- Electrical interference on the signal line low
Symptoms
- MIL on, sometimes clearing by itself
- Surging or hesitation
- Uneven idle
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P264E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.