P264D
"A" Rocker Arm Actuator Position Sensor Circuit High (Bank 1)
With P264D the position signal of actuator A on bank 1 reads above its plausible maximum. An open ground return, a signal line touching the 5 V or battery feed, or water in the connector can push it up. Because a reading at the upper stop looks like an impossible position, the controller rejects it and runs a fixed lift. No public manufacturer documentation gives a threshold; the regulatory basis is CARB's demand to check every input of a variable lift system for out-of-range values. Toyota's Valvematic engines show that such feedback exists, though Toyota files its sensor faults under the B codes. Compare with P264C (low) and P264E (intermittent).
Possible causes
- Open sensor ground high
- Signal wire shorted to 5 V or battery voltage medium
- Water ingress in the sensor connector low
Symptoms
- MIL on
- Engine runs on a fixed lift setting
- Noticeably less power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P264D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.