P264C
"A" Rocker Arm Actuator Position Sensor Circuit Low (Bank 1)
P264C is set when the signal from the position sensor of rocker arm actuator A, bank 1, sits below its valid window. Typical electrical explanations are a short of the signal wire to ground, a lost 5 V reference, or a sensor that has failed internally. CARB lists such out-of-range checks for every sensor in a lift or timing system under the comprehensive component rules. No carmaker publishes P264C with a threshold; it would only appear on engines whose actuator carries position feedback, such as motor-driven continuous lift designs. Expect the controller to stop adjusting lift, with weaker pull and higher consumption; P264D is the high-side counterpart.
Possible causes
- Signal wire shorted to ground high
- 5 V sensor supply missing medium
- Position sensor failed internally medium
Symptoms
- MIL on
- Weaker pull, lift no longer varied
- Higher fuel consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P264C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.