P2649
"A" Rocker Arm Actuator Control Circuit High (Bank 1)
The counterpart to P2648: the control circuit of rocker arm actuator A on bank 1 reads high, which means a short to battery voltage or a driver that cannot pull the line down. In GM's 2015 table 15OBDG05 the check needs the output driver commanded on, ignition in crank or run and supply above 11 V; 100 failures in 120 samples set a Type A fault. The Honda V6 (L66) in GM's 2004 table looks at the opposite situation: with the VTEC solenoid commanded off, a return signal at 12 V lasting 2 s points to a high circuit. A harness shorted to a power feed or an internal controller fault are the usual suspects; the actuator can then stay energised or be shut down by the controller.
Possible causes
- Control wire shorted to a battery or ignition feed high
- Output driver in the engine controller no longer switches medium
- Open ground side of the solenoid circuit low
Symptoms
- MIL on immediately
- Lift switching disabled or permanently active
- Rough running at idle if the actuator stays energised
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2649
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.