P2645
"A" Rocker Arm Actuator Control Circuit/Open (Bank 1)
Engines that switch valve lift or deactivate cylinders through their rocker arms use an actuator, usually an oil control solenoid, to send oil to the locking pins. P2645 means the engine controller sees the drive circuit of actuator A on bank 1 as open: the state it commands and the state it reads back on the line disagree. GM's 2015 four-cylinder table 15OBDG05 runs this check wherever VVL hardware is fitted, needs more than 11 V, counts 100 failures within 120 samples taken every 250 ms and sets a Type A fault with the MIL on the first trip. P2648 and P2649 cover shorts to ground and to power. The engine stays in its default lift, so power at high revs or economy suffers.
Possible causes
- Open coil in the rocker arm oil control solenoid high
- Loose, corroded or oil-soaked solenoid connector medium
- Broken wire in the control or supply line medium
- Faulty output driver in the engine control module low
Symptoms
- MIL on, often on the first trip
- No change to high lift, weak pull at high engine speed
- Cylinder deactivation or economy mode no longer engages
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2645
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.