P2644
Torque Management Feedback Signal B High
P2644 reports that torque management feedback B exceeds its upper range limit. No manufacturer publishes a code-specific description. The closest documented case is Allison's P2641: a 2013 Cummins ISX12 calibration reported more torque than the low-range cap allowed, and Mack and Volvo trucks showed the same code under heavy load until the engine software was updated. A reading that is not just above the cap but beyond any valid value points to the same family of problems, namely engine software that scales or encodes the torque message differently from what the transmission expects, or a wired signal shorted to voltage. Low ranges may be locked out and the warning lamp lit. P2643 is the low fault, P2640 the high fault of signal A.
Possible causes
- Engine software sends torque with a scaling the transmission does not expect high
- Engine calibration older than the level required by the transmission maker medium
- Wired feedback line shorted to voltage low
Symptoms
- Transmission warning lamp on
- Low ranges blocked
- Shift quality reduced
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2644
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.