OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2643

Torque Management Feedback Signal B Low

With P2643 the transmission controller sees feedback signal B below its lower limit, so it cannot confirm that the engine is holding the torque level it asked for. No manufacturer describes this exact code in public documents. Where the feedback is a data-link message, as with Allison transmissions behind Cummins, Mack, Volvo or Navistar engines, a low value tends to come from a missing or defaulted message, an incompatible calibration or a bus fault; on a wired signal a short to ground is the classic cause. CARB requires comprehensive components to be tested against their range limits. Because Allison ties request B to Low Range Torque Protection, the TCM may lock out low ranges when it cannot verify the limit. P2644 is the high counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 43

Possible causes

  • Torque message missing or sent with a default value on the data link high
  • Engine and transmission calibrations incompatible medium
  • Bus or signal wiring damaged, short to ground low

Symptoms

  • Transmission warning lamp on
  • Low ranges or reverse low not selectable
  • Harsh shifts because torque reduction is missing

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2643

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication