OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2641

Torque Management Feedback Signal B

On Allison automatics, feedback B belongs to Low Range Torque Protection (LRTP): in the low ranges the TCM caps engine torque to spare gears and output shaft and checks that the engine respects the cap. P2641 sets when the engine reports more torque than permitted. Allison bulletin TT7401EN describes 2013 Cummins ISX12 engines with 4700/4800 transmissions: at idle in Low Reverse the ECM broadcast a wrong torque value, CHECK TRANS came on and Low Reverse was blocked until the ECM received calibration PH9.30.0.6 or later. Mack and Volvo tech tip TT-013-2015 sees the code under heavy load without drivability effects and also prescribes newer engine software. Navistar names it for Allison 1000/2000 calibrations. P2637 is the counterpart for request A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 41

Possible causes

  • Engine ECM software below the level required for the transmission (Cummins, Mack, Volvo) high
  • Engine broadcasts torque above the low-range limit requested by the TCM medium
  • Transmission calibration not matched to the engine low

Symptoms

  • CHECK TRANS lamp on
  • Low Reverse or other low ranges unavailable
  • Code appears under high load, often without noticeable drivability change

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2641

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication