OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2640

Torque Management Feedback Signal A High

P2640 is the high-range fault of torque management feedback signal A: the confirmation that the transmission controller receives after asking the engine for a torque change carries a value above the plausible upper limit. On Allison-equipped trucks this feedback is not a separate wire but part of the engine data broadcast on the J1939 link, so a high reading usually means the engine claims more torque than is physically possible or than was requested. No manufacturer documents P2640 publicly. For the related P2637 Cummins cured the fault with new ECM calibrations, a hint that software mismatches are a frequent root. P2637, P2638 and P2639 cover the general, plausibility and low faults of signal A. Expect harsher shifts and torque reductions that no longer work.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 40

Possible causes

  • Engine ECM software reports torque values the transmission calibration does not accept high
  • Outdated or wrong transmission controller calibration medium
  • Hard-wired feedback line shorted to voltage (where used) low

Symptoms

  • Check transmission lamp or MIL on, depending on calibration
  • Firm or abrupt upshifts
  • Torque reduction during shifts no longer active

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2640

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication