P263F
Glow Plug Control Module 2 Over Temperature
P263F is reserved for engines with a second glow plug control module, for instance one per cylinder bank on large V engines; it reports that this second unit has exceeded its permitted internal temperature. No manufacturer documents P263F publicly, and the documented North American V8 diesels from Ford and GM manage all eight plugs with a single module, so they only use the module 1 code P263E. The logic would match that code: GM's L5P sets module 1 overheating above 123 °C during glowing, Ford's 6.7 L above 125 °C. CARB requires glow plugs to be monitored as one component. Likely triggers are high-current or shorted plugs on the bank served by module 2, extended glowing in severe cold, or an internal module fault. Cold starting suffers on one bank.
Possible causes
- High-current or shorted glow plugs on the bank served by module 2 high
- Long or repeated glow phases in severe cold medium
- Internal fault or poor cooling of glow plug module 2 medium
Symptoms
- Check engine light, glow lamp flashing
- Harder cold start, uneven running until warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P263F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.