OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P263E

Glow Plug Control Module 1 Over Temperature

The first glow plug control module measures its own internal temperature and reports P263E when it runs too hot, since its power semiconductors carry tens of amps during glowing. GM's 6.6 L L5P Duramax tables set it at a module temperature above 123 °C while the plugs are commanded on and coolant is below 60 °C, type B. Ford's 2023 diesel summary for the 6.7 L and 3.0 L names more than 125 °C inside the module. FCA bulletin 09-009-15 for 2014-15 Ram ProMaster vans with the 3.0 L diesel lists P263E among glow plug codes caused by plugs lacking an internal O-ring and replaces all four plugs. Heat can also come from repeated or very long glow cycles in deep cold. Driver faults are P263C, a second module would report P263F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 3E

Possible causes

  • Defective glow plugs drawing excess current (e.g. Ram ProMaster plugs without O-ring) high
  • Repeated start attempts or very long glow periods in severe cold medium
  • Internal fault or poor heat dissipation of the glow plug module medium

Symptoms

  • Check engine light, glow lamp flashing
  • Glowing cut short, hard cold starts
  • White smoke after cold start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P263E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication