OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P263C

Glow Plug Control Driver Performance

Modern diesel glow systems switch each plug through a semiconductor driver inside a glow plug control module (GPCM). P263C reports that such a driver does not behave as commanded. Ford's 6.7 L and 3.0 L Power Stroke GPCM talks to the engine module over a private CAN bus and flags any internal output, whether it serves the plugs, the DEF heaters or a relay, that fails to switch or overheats for more than 1 s; Ford's 2013 summary prints the code with a typo as P26C3. GM's 6.6 L L5P files comparable driver faults under P064C instead. Separate codes exist for the module as a whole (P064C, P06E5), its overheating (P263E) and open plugs (P0671 ff.). CARB counts all glow plugs as one monitored component. Expect slow cold starts and white smoke.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 3C

Possible causes

  • Output stage inside the glow plug control module failed high
  • Glow plug or plug wire with short, overloading the driver medium
  • Poor GPCM power feed or ground causing erratic switching low

Symptoms

  • Check engine light, glow indicator may flash
  • Hard or long cranking when cold
  • White smoke and rough running after a cold start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P263C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication