OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P263B

MIL Control Circuit High

P263B is stored when the MIL control line is stuck at supply voltage while the module has switched its driver on to light the lamp. GM treats an impedance toward power of about 0.5 ohm as the fault and needs 4 failures within 5 samples, each 50 ms apart, provided run/crank voltage is at least 11 V and no remote start is running. As with P263A, GM labels the code Type B with no MIL, because a shorted control circuit cannot reliably show the warning. In practice the indicator stays dark even when other emissions faults are present, which is why reading stored codes matters, also before an emissions inspection. GM's PIT5391 bulletin ties P263B on 2014–2016 full-size trucks and SUVs to a missing ignition 1 supply. Check the cluster wiring and the driver output.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 3B

Possible causes

  • MIL control wire shorted to a positive feed high
  • Ignition 1 supply interrupted at relay or fuse block medium
  • Lamp driver in the engine module failed low

Symptoms

  • Engine warning lamp does not light, not even at key-on bulb check
  • Other emissions codes stored without warning

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P263B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication