P263A
MIL Control Circuit Low
P263A means the engine module has found the line that switches the malfunction indicator lamp shorted to ground. GM checks it while the low-side driver is off: if the voltage stays low with an impedance to ground of about 0.5 ohm, the lamp control is faulty; the 2014 tables need 50 of 63 samples at 50 ms intervals, the 2019 tables a single sample, with run/crank voltage of at least 11 V and remote start inactive. GM files it as Type B but marks it no MIL, which makes sense because the lamp itself is the affected part; some controllers also log P0650. GM preliminary information PIT5391 lists P263A and P263B among codes left behind when ignition 1 voltage drops out through a KR73 relay or terminal fault on 2014–2016 trucks. A permanently lit lamp is the main symptom.
Possible causes
- MIL control wire chafed and touching ground high
- Loss of ignition 1 voltage via main relay or fuse block terminal medium
- Faulty lamp input in the instrument cluster low
Symptoms
- Engine warning lamp lit permanently
- Code stored even though the lamp cannot report it reliably
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P263A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.