OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2638

Torque Management Feedback Signal A Range/Performance

P2638 says the torque feedback for request A is present but its value does not fit the situation, for example an engine torque figure that drifts away from what the transmission expects during a shift. Honda documents it on its nine-speed automatic: on low-mileage 2016 Pilots the MIL lit and the gear indicator flashed because the idle learn had not been done properly before delivery, so the fix is a PCM reset with the HDS and a correct idle relearn. Service bulletins 16-008 (Pilot) and 16-012 (Acura TLX V6) later improved the torque accuracy monitoring behind P2638 by TCM software, again followed by an idle learn. Unlike P2637, where the engine ignores the request, here the reported torque is implausible. Drivers notice rough or delayed shifts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 38

Possible causes

  • Idle learn not completed after PCM reset or delivery high
  • Outdated transmission software with oversensitive torque monitoring medium
  • Engine torque estimate skewed by air leaks or sensor errors low

Symptoms

  • MIL on and gear position indicator flashing
  • Rough or delayed gear changes

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2638

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication