OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2637

Torque Management Feedback Signal A

Many automatic transmissions ask the engine to cut torque briefly during an upshift and then check whether the engine actually did so. P2637 is stored by the transmission controller when that feedback for request A shows the engine did not follow. Allison names it Shift Energy Management (SEM) on its 3000/4000 series: behind Cummins L9 and X15 engines (EPA17 version) the engine failed to track the torque request closely enough, the CHECK TRANS lamp came on and Cummins fixed it with an ECM recalibration (TSB210020), with no change to Allison hardware or software. Cummins found the same on B6.7 engines in 2017 (J1939 SPN 513, FMI 7), and Navistar linked P2637 to Allison 1000/2000 calibrations causing quick, harsh upshifts. P2641 covers request B. Expect firm shifts or limited gears.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 37

Possible causes

  • Engine control module calibration not following the torque reduction request high
  • Transmission calibration not matched to the engine medium
  • J1939/CAN data link fault between engine and transmission low

Symptoms

  • Check transmission lamp on
  • Harsh or too quick upshifts
  • Gear range limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2637

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication