OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2634

Fuel Pump B Control Circuit High

P2634 indicates that the drive of the second fuel pump reads as shorted to battery voltage or carries too much current. For the 6.6 L LML with dual tanks, GM's 2014 table judges the transfer pump relay output while it is switched on and treats 0.5 ohm or less toward controller power, lasting 3 s, as a Type B fault. GM's 2020 diesel table checks the transfer pump driver while it is off instead and logs a Type C code after 20 of 25 samples; it notes that the open-circuit code P2632 may appear alongside. VW uses an overcurrent limit of 1.0 A for the in-line pump on 2014 Golf/GTI and Beetle. A pump with worn brushes or a shorted relay coil can cause it as well as damaged wiring. The open and low faults are P2632 and P2633.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 34

Possible causes

  • Control wire shorted to a battery-voltage feed high
  • Worn or binding pump drawing excess current medium
  • Relay with shorted coil or stuck contacts low

Symptoms

  • Second pump runs constantly or is shut off by the module
  • Fuel level display between tanks inconsistent
  • Warning lamp depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2634

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication