OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2631

O2 Sensor Pumping Current Trim Circuit High (Bank 2 Sensor 1)

P2631 flags a trim value above the valid window for the first wide-band probe on bank 2. Ford assigns it to NTK probe installations: the interface chip notices the resistor line pulled up to battery voltage, as from a chafed wire touching a powered circuit. GM's 2005 table for the 3.5 L V6 of Honda origin uses the mirror logic, with the bank 2 label resistor voltage below 0.29 V for 5 s. CARB requires front air-fuel ratio sensors to be checked for wiring defects and for readings beyond their valid span that would disable closed-loop fuelling, which is what such a reading does. A harness short can also hit other circuits in the same loom, so check for neighbouring codes first. Bank 1 high is P2628; P2630 is the low fault and P2629 the open fault on this probe.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 31

Possible causes

  • Bank 2 resistor line shorted to a powered wire in the harness high
  • Bank 2 front probe with internal short medium
  • Non-matching replacement probe or repaired connector without the original resistor low

Symptoms

  • Check engine light
  • Lambda control on bank 2 disabled
  • Possibly additional circuit codes from the same harness

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2631

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication