OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2630

O2 Sensor Pumping Current Trim Circuit Low (Bank 2 Sensor 1)

P2630 reports a trim input that is too low at the upstream wide-band probe of bank 2, the cylinder bank without cylinder 1. Ford's petrol summaries of 2020-23 set it only with NTK probes, where the sensor interface chip sees the resistor line open or grounded; the same chip check runs for about 10 s before a fault is stored. GM documented the L66 3.5 L V6, a Honda design, in 2005: the bank 2 label resistor must not stay above 4.7 V for 5 s while the probe heater is active, and that table also files this under the low code. No service bulletin naming P2630 was found. Since only one bank is affected, the other bank keeps normal closed-loop control. The open fault on this probe is P2629, the high fault P2631, bank 1 low P2627.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 30

Possible causes

  • Resistor line of the bank 2 probe open or rubbed through to ground high
  • Bank 2 upstream probe internally defective medium
  • Damaged or heat-affected connector near the exhaust low

Symptoms

  • Check engine light
  • Bank 2 running in open loop
  • Fuel economy slightly worse

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2630

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication