P262F
Sensor Reference Voltage G Circuit Range/Performance
P262F is the plausibility check of reference output G. The voltage is neither shorted nor missing, yet it wanders outside a tighter tolerance band or jumps around, which falsifies every ratiometric sensor on that circuit. Ford's 2012 summary shows the idea for its references A to C on Bosch Tricore modules: below 4.7 V or above 5.2 V for 0.5 s counts as a range fault. GM goes further on its numbered references and also compares the filtered with the unfiltered value, failing when they drift apart, so short dropouts are caught as well. No manufacturer documents P262F publicly. Typical sources are a poor ground at the module, a loose pin that opens briefly under vibration, or a sensor drawing too much current. P262C to P262E are the circuit faults on G.
Possible causes
- Poor ground connection of the engine module medium
- Loose pin or splice on circuit G opening briefly under vibration high
- Sensor on the group drawing excessive current medium
- Drifting internal regulator of the engine module low
Symptoms
- Check engine light
- Sporadic implausible values from several sensors
- Occasional hesitation or limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P262F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.