P262C
Sensor Reference Voltage G Circuit/Open
Engine modules supply groups of sensors from separately regulated 5 V outputs, lettered A, B, C and so on; G is the seventh such supply. P262C is the general fault of this output, typically an interruption so that the sensors behind it lose their feed and report signals near zero together. No manufacturer documents P262C publicly, and which sensors hang on circuit G depends entirely on the application. Comparable checks exist for earlier letters: GM monitors its fifth reference with a single collective code (P06D2) and a window of 4.875-5.125 V, type A; Ford checks reference A for shorts to earth or to the battery, with a 5 s debounce. CARB treats such outputs as monitored comprehensive components. Low, high and plausibility faults of circuit G are P262D, P262E and P262F.
Possible causes
- Broken reference wire or splice feeding the sensors of circuit G high
- Loose or corroded pin at the engine module or a sensor plug medium
- Internal regulator of the engine module for output G failed low
Symptoms
- Check engine light
- Several sensor codes appearing at the same time
- Reduced power or limp mode depending on the affected sensors
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P262C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.