P262B
Control Module Power Off Timer Performance
P262B concerns the timer that keeps counting inside a control module while the vehicle is shut down, used to measure how long it has been off. GM runs two checks on it: a count-up test while run/crank is inactive, failing when two consecutive readings differ by over 1.5 s in 4 of 20 one-second samples, and a range test comparing the hardware timer with a mirror timer at shutdown or restart (deviation above 25 % in the 2014 tables). It is Type B, so the MIL follows on the second trip. GM saw false sets on 2019–2020 CT6 4.2 L engines when the engine cooled faster than expected, for example in wind or an air-conditioned garage (PIP5754: clear the code and keep the ECM), and links P262B to ECM supply or ground faults (PIP5609) and to a lost ignition relay feed (PIT5391).
Possible causes
- Poor ECM power or ground connection, momentary supply loss high
- Ignition relay or its control circuit not supplying the module medium
- Diagnostic calibration too sensitive to fast engine cool-down medium
- Internal timer hardware fault in the control module low
Symptoms
- MIL on after two drive cycles
- Possibly other control module codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P262B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.