OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2626

O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)

Wide-band lambda probes such as the Bosch LSU 4.9 carry a calibration resistor in their plug; the engine module uses it to scale the pumping current. P2626 says this trim path at the front probe of bank 1 looks open. Makers detect it differently: GM's 2023 tables let the sensor chip measure the resistor after each start and fail an LSU 4.9 above 379.5 ohms (NGK ZFAS-U2: above 4,644 ohms), type B. VW's 2014 data books flag a probe signal above 4.81 V, and the 2010 Saab 9-5 applies that limit during fuel cut-off (type B). Ford's Bosch-equipped engines run an air test in overrun and fail a pump current above 3.09 mA held for 2 s. Ford's TSB 17-2124 for the 3.5 L EcoBoost in Explorer and F-150 (2015-17) cures it with a new probe. Low and high faults are P2627/P2628; bank 2 is P2629.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 26

Possible causes

  • Front wide-band probe defective (trim resistor, pump cell or heater damage) high
  • Trim line broken or pin pushed back in the six-pin probe connector medium
  • Moisture or corrosion in the probe connector raising the measured resistance low
  • Engine software requiring an update after probe replacement (some makes) low

Symptoms

  • Check engine light
  • Fuel control falls back to open loop on bank 1
  • Slightly higher fuel consumption or rough idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2626

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication