OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2622

Throttle Position Output Circuit High

P2622 means the throttle position output line sits too high, typically because it is shorted to a supply wire or the driver in the sending module cannot pull it down. The receiver would read a value resembling wide-open throttle even at idle, which can confuse shift scheduling or torque calculations. There is no public manufacturer documentation for this exact code. CARB's comprehensive component rules oblige makers to detect shorts on output circuits, and GM's short-to-power check on its crank output (impedance toward power of 0.5 ohm or less, sampled every 100 ms) shows how such a test is commonly built. Inspect for a wire rubbing against a battery or ignition feed and for back-feed through a connector. P2620 is the open line and P2621 the short to ground.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 22

Possible causes

  • Output wire shorted to a battery or ignition feed high
  • Driver in the sending module unable to pull the line low medium
  • Back-feed through a damaged connector low

Symptoms

  • Stored code in the engine module
  • Receiver acts as if at full throttle (harsh or late shifts)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2622

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication