OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2620

Throttle Position Output Circuit/Open

P2620 concerns a line on which the engine module sends a throttle position value out to another unit, for instance a transmission or body controller, as an analogue or pulse-width signal. The code means the module detects that this output circuit is open, so the receiver gets nothing usable. No manufacturer documents P2620 publicly with thresholds; Ford includes it in its 2014 code interpretation list without a MIL marker, and the CARB rules require output circuits to be checked for continuity and shorts. GM's crank-output diagnostics (P2618) show how such a driver test typically works: the module compares the voltage on the line with what it commands. P2621 and P2622 are the shorted variants, while P0121–P0123 concern the throttle sensor itself. Shifting or idle control in the receiving module may be affected.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 20

Possible causes

  • Open wire or loose pin on the throttle position output line high
  • Corroded connector at the sending or receiving module medium
  • Output stage in the engine control module defective low

Symptoms

  • Stored code, warning lamp behaviour depends on the maker
  • Irregular shift points or idle control in the receiving module

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2620

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication