OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P261F

Coolant Pump A Control Circuit Stuck On

P261F means electric coolant pump A reports activity while the module has it switched off. GM's 2025 ECM table 25OBDG04B describes the test: with the pump commanded off or below 299 rpm for 2 s and more than 11 V on board, a feedback speed of 3,100 rpm or more for 8 of 10 seconds sets the code as Type B; the warning lamp follows on the second faulty trip. Bulletin 22-NA-077 shows how that can fail without a defect: on 2021-2022 Blazer, Acadia, XT5 and XT6 with the 3.6 L LGX, high engine speed pushes so much coolant through the auxiliary pump that its impeller free-spins above the limit; GM reflashes the ECM and warns against replacing the pump. Mercedes lists P261F71 on the OM651 Sprinter with vacuum leaks or a damaged water pump. P261E is pump B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 1F

Possible causes

  • Impeller driven by main pump flow at high rpm, fixed by ECM software (GM) high
  • Vacuum leak or contaminated switching valve of a switchable pump (Mercedes OM651) medium
  • Pump electronics reporting wrong speed or not switching off low

Symptoms

  • Check engine lamp after two faulty trips
  • Usually no noticeable driveability change
  • Slower warm-up when the pump really keeps running

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P261F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication