P2619
Crankshaft Position Signal Output Circuit High
P2619 is set when the crankshaft position output line is held at supply voltage while the module's low-side driver is switched on and expects it to be pulled down. GM's 2014 hybrid ECM table treats an impedance of 0.5 ohm or less toward power as the fault and evaluates it like the low case: 40 failures in 50 samples every 100 ms, engine not cranking, relay voltage of 11 V or more, Type B with MIL after two trips. GM also carries the code in its 2011, 2012, 2016 and 2023 tables, and Mitsubishi lists it for the 2022 Outlander. The usual cause is insulation damage that lets the line touch a positive feed, less often a defective output stage in the module. The listening controller then receives a constant level rather than teeth and may limit operation.
Possible causes
- Damaged insulation lets the output touch a positive feed high
- Low-side driver in the engine module failed open medium
- Back-feed through a corroded connector low
Symptoms
- MIL on after two drive cycles
- Receiving module reports implausible crank signal
- Possible reduced power or start problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2619
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.