OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2617

Crankshaft Position Signal Output Circuit/Open

When an engine module relays the crankshaft position signal to another controller, P2617 says that this forwarded line is open or the pulses go missing at the receiver. Ford's 2003 6.0 L diesel summary describes the clearest case: the fuel injector control module counts a fault whenever the crank pulse it gets from the PCM is absent or does not line up with the camshaft signal, monitored continuously above 90 rpm, and the code carries a MIL in Ford's lists. GM notes that some of its controllers may store P2617 alongside P2618 when the output is open, and Mitsubishi lists P2617 for the 2022 Outlander. Low and high shorts are P2618 and P2619; a fault in the crank sensor itself is P0335/P0336. Without the copied signal the injectors may not fire, so stalling or a no-start is typical.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 17

Possible causes

  • Open wire or pushed-out pin on the crank output line high
  • Crank sensor signal itself missing or out of sync with the cam signal medium
  • Receiving module (e.g. injector control module) faulty low

Symptoms

  • Malfunction indicator lamp on
  • Engine cranks but does not start
  • Sudden stalling while driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2617

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication