OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2616

Camshaft A Position Signal Output Circuit High (Bank 1)

P2616 is the opposite fault to P2615: the outgoing camshaft A position line on bank 1 stays at supply potential although the module has switched its low-side driver on and wants the line low. In GM's 2018 CT6 tables the ECM declares a power short once the impedance toward the supply is 0.5 ohm or less, using the same window of 40 bad readings in 50 at 100 ms intervals, engine not cranking and at least 11 V; the code is Type C, so the warning lamp stays off. A chafed wire touching a battery feed or a failed output stage are the usual suspects. Mitsubishi also lists P2616 for the 2022 Outlander. The downstream controller sees a steady level instead of pulses, which can upset cam phasing or starting.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 16

Possible causes

  • Output wire shorted to a battery or ignition feed high
  • Low-side driver in the engine module no longer switching medium
  • Back-feed through a damaged or corroded connector low

Symptoms

  • Stored code without warning lamp
  • Hard starting or hesitation after start
  • Cam phasing faults logged by the receiving module

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2616

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication