Powertrain
generic / SAE
P2614
Camshaft Position Output Circuit/Open
The camshaft position output signal sent from the ECU to other modules is interrupted. Other systems that rely on the cam reference (e.g. transmission, hybrid module) do not receive a valid signal.
SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 14
Possible causes
- Open output wiring high
- Internal ECU output driver fault low
- Pin pushed back out of connector body low
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
- Estimated cost: 80–400 €
- Estimated time: 0.5–2 h
- Component: camshaft position sensor
- Component: cmp signal wiring
- MIL / check engine light
- emissions-relevant
- drive cycle required
Sources
References
sae:J2012