P260E
Particulate Filter Regeneration Lamp Control Circuit
Diesel machines often have a separate dashboard lamp that tells the operator a particulate filter regeneration is needed or running. P260E covers the circuit that switches this lamp. Deutz documents it for its EMR5/MD1 engine controllers: fault type 11 (J1939 SPN 3697, FMI 4) means the lamp output reads below normal or is shorted to ground, type 12 (FMI 3) means it is too high or shorted to the supply. Deutz engines go into tractors, construction and other off-road equipment, so the code is mostly met there. For on-road heavy-duty engines CARB section 1971.1 requires electrical checks of such output components. A failed lamp output does not affect the filter itself, but the operator may miss a request for a parked regeneration, letting soot load build up until power is reduced.
Possible causes
- Lamp wire shorted to ground or to supply high
- Lamp or bulb holder open, or lamp not fitted on this machine medium
- Corroded connector at dashboard or engine controller low
Symptoms
- Regeneration lamp dark or permanently lit
- Missed regeneration requests leading to high soot load
- Later power reduction by the engine controller
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P260E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.