P260A
PTO Control Circuit/Open
P260A reports an open circuit in the output a control module uses to engage the power take-off, typically the coil circuit of a PTO relay or engagement solenoid. GM's PTO module on 2008-2014 Silverado/Sierra 3500 HD chassis cabs, described in upfitter bulletin UI 80c, switches both the supply and the ground side of an upfitter-installed relay and refuses PTO operation unless both lines are connected; GM also notes that the relay output is disabled from the factory and must be programmed on. GM's PTO code table lists the low and high faults of this relay output, but not P260A, so no manufacturer documents this exact code publicly. CARB defines a PTO unit as engine-driven equipment for bodies such as dump beds or winches. The PTO stays disengaged, while normal driving is unaffected.
Possible causes
- Relay coil wiring missing, broken or only one side connected by the upfitter high
- Open coil in the PTO relay or engagement solenoid medium
- Corroded or loose connector in the chassis wiring medium
Symptoms
- PTO does not engage
- PTO indicator flashes or stays off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P260A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.