P2608
Intake Air Heater B Circuit High
P2608 is logged when the circuit of intake air heater B reads too high, for instance a short to battery positive on the control line or a relay that stays energized when it should be off. Volvo is the one maker that names it in public bulletins: the August 2020 EMS change log for heavy-truck engines lists P2608-00 among the preheater codes reduced by a relay robustness update, and Volvo's 2022 instruction for the pre-heat relay on 11 L and 13 L engines includes P2608-7E in its scope before replacing relay and supply cable. Deutz uses P0542 with the same meaning for its preheating relay. A heater stuck on drains the batteries and can overheat cables; a dead heater makes cold starts hard. P2607 is the low-side code, P2605 the open circuit.
Possible causes
- Preheat relay contacts welded or sticking closed high
- Control or feedback wire shorted to battery positive medium
- Engine software needing the maker's update low
Symptoms
- MIL on
- Batteries run down after short trips or standstill
- Hard cold starts or white smoke
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2608
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.