OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2607

Intake Air Heater B Circuit Low

P2607 says the signal from the circuit of intake air heater B stays too low, which normally means a grounded control or feedback line, or a relay output pulled down. No manufacturer documents P2607 publicly. The closest published equivalents are Deutz, whose MD1 code list files an under-voltage or ground short at the preheating relay of heater A as P0541, and Volvo, whose 2020 engine software list contains the low-side code P2CE3-11 for heater C but none for B. CARB asks for the heater circuit to be monitored for current and voltage drop, which is how such a low reading becomes visible. P2608 is the high-side counterpart, P2605 the open circuit, P2606 the plausibility check. With heater B unusable, cold starts take longer and the engine smokes white at first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 07

Possible causes

  • Control or feedback wire chafed through to ground high
  • Internal short in the preheat relay medium
  • Moisture or corrosion in a connector of the heater circuit low

Symptoms

  • Hard starting in cold weather
  • White smoke after a cold start
  • MIL on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2607

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication