P25F0
Vacuum Pump Control Circuit B Low
P25F0 is stored when the pump's B control circuit reads lower than expected, usually because the switched supply or feedback line is shorted to ground or loaded down by a pump motor with an internal short. A short to ground on the supply side often blows the pump fuse, so the pump then stops altogether. No manufacturer documents P25F0 publicly. Ford's hybrid OBD summary uses a lower limit of 250 mV on the monitoring line for the open-type fault P25EE; a low fault on the same circuit would be judged against a comparable voltage window. The difference from P25EE: there the line is simply without voltage, here the module sees a load or a short pulling it down. CARB lists such outputs among the comprehensive components. Braking assist can fade, and P0556 or P050F may follow.
Possible causes
- Chafed supply or feedback wire shorted to ground high
- Internal short in the vacuum pump motor medium
- Water ingress in the pump connector low
Symptoms
- Hard brake pedal
- Repeatedly blown vacuum pump fuse
- Warning lamp on
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25F0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.