OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25E8

"B" Camshaft Position Control Performance (Bank 2)

P25E8 is the last code of the locked-position block and covers the control quality of the bank 2 exhaust camshaft actuator: the module sees the angle wander from, overshoot or trail its setpoint more than allowed, while lock-related faults are absent. Older codes such as P0024 and P000D describe similar exhaust deviations on bank 2; which one a given calibration uses is not documented publicly by any manufacturer, so P25E8 should be read together with any accompanying cam codes and live phaser data. CARB 13 CCR 1968.2 demands that any VVT system be watched for wrong angles and sluggish travel. In hydraulic phasers like BorgWarner's torsional-assist units, oil viscosity, filter condition and wear in the valve or rotor seals decide how well the angle holds. Symptoms are usually subtle, such as uneven idle or higher fuel use.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / E8

Possible causes

  • Wear in the bank 2 exhaust control valve high
  • Wrong oil viscosity or a clogged oil filter medium
  • Worn rotor seals inside the exhaust phaser low

Symptoms

  • Check engine lamp on
  • Uneven idle
  • Higher fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication