P25E7
"B" Camshaft Position - Unable to Achieve Locked Position (Bank 2)
With P25E7 the module reports that the bank 2 exhaust phaser could not be brought into its locking position: when the lock is requested, the cam angle does not settle at the parking value or the pin does not hold it there. A start without the pin engaged tends to be rough, and on stop-start engines a smooth restart becomes less certain. No manufacturer documents P25E7 publicly; the closest documented case is P25E4 on bank 1 of Stellantis' Hurricane six, which was resolved by PCM software. Mechanically, mid-lock designs such as BorgWarner's need the rotor to swing past the slot on oil-driven cam torque, so degraded oil, a stuck spool valve or wear in the pin and its bore are usual causes. CARB treats a pin that does not move into position as a VVT fault the OBD system must detect.
Possible causes
- Aged or sludged oil slowing the bank 2 exhaust phaser high
- Spool of the bank 2 exhaust control valve hanging medium
- Worn lock pin or pin bore so the pin no longer holds medium
- Calibration issue fixed by a control unit update low
Symptoms
- Check engine lamp on
- Rough or rattling start
- Hesitant restart after an automatic engine stop
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P25E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.