P25E5
"B" Camshaft Position Control Performance (Bank 1)
P25E5 reports that the exhaust camshaft actuator on bank 1 is controlled less precisely than intended: its angle lags, overshoots or oscillates around the target beyond calibrated limits, without a latch fault. It is the exhaust-side counterpart of P25DF and overlaps in meaning with P0014 and the slow-response code P000B; no manufacturer documents how P25E5 is told apart from them. CARB 13 CCR 1968.2 requires detection of missed targets and slow phasing for all VVT hardware. In a hydraulic phaser like those BorgWarner supplies for Hyundai's Gamma II, exhaust adjustment depends on cam torque pulses and on clean oil passages in the centre bolt valve, so oil condition and valve wear are the first checks. Drivers may notice unsteady idle, slightly reduced power or poorer economy.
Possible causes
- Worn or dirty control valve for the bank 1 exhaust phaser high
- Degraded engine oil or a blocked oil filter medium
- Noisy exhaust camshaft position signal making the angle look unstable low
Symptoms
- Check engine lamp on
- Unsteady idle
- Slightly reduced power or economy
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25E5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.