OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25E4

"B" Camshaft Position - Unable to Achieve Locked Position (Bank 1)

P25E4 means the bank 1 exhaust phaser does not reach and engage its locking position when the controller asks for it, for example before shutdown or an automatic engine stop. Stellantis lists P25E4 in several PCM reflash bulletins for Wagoneer and Grand Wagoneer models with the 3.0-litre Hurricane high-output twin-turbo inline six and stop-start, among them 18-022-25 Rev. A for 2025 and 18-040-26 for 2022; the remedy there is new software, and the listed complaints include no restart after a stop-start event. An inline six only has bank 1, so the bank 2 code P25E7 does not apply there. Outside such software cases, low oil pressure at hot idle, debris in the phaser or a sticking control valve keep the pin from dropping in. CARB lists a pin that fails to move into place as a fault the VVT monitor must find.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / E4

Possible causes

  • Engine control software needing an update (documented for Stellantis Hurricane engines) high
  • Low oil pressure at hot idle so the phaser cannot swing into the lock medium
  • Debris in the exhaust phaser or a sticking control valve medium

Symptoms

  • Check engine lamp on
  • Engine fails to restart after an automatic stop, restarts after an ignition cycle
  • Rough start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25E4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication