OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25E0

"A" Camshaft Position - Stuck In Locked Position (Bank 2)

On engines with two cylinder banks, P25E0 is the bank 2 counterpart of P25DD: the intake camshaft actuator stays latched at its locking angle when the module wants it free to advance or retard. Because only one side is affected, the cam angles of the two banks no longer match, and the module may hold both sides in a fallback position. Ford's 2014 OBD-II code interpretation list for the Boss 302S V8 includes P25E0 among four lamp codes for a phaser stuck in its lock. A pin that fails to retract usually goes back to oil supply: too little pressure at that head, wrong viscosity, a clogged feed screen or a sticking control valve; less often the pin is jammed mechanically. CARB requires the OBD system to detect valve timing that cannot reach its target. Typical complaints are low power, rough idle and higher consumption.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / E0

Possible causes

  • Insufficient oil pressure at the bank 2 head, low level or clogged feed screen high
  • Bank 2 intake oil control valve sticking medium
  • Lock pin mechanically jammed in the phaser low

Symptoms

  • Check engine lamp on
  • Reduced power and rough idle
  • Higher fuel consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P25E0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication