P25DE
"A" Camshaft Position - Unable to Achieve Locked Position (Bank 1)
P25DE is the reverse of P25DD: the intake cam phaser on bank 1 should return to its lock angle and let the pin engage, typically as the engine is about to stop or idles before an automatic stop, but the controller never sees the expected locked position. If the pin is not in place at the next start, the rotor can rattle against its stops and timing wanders until oil pressure takes over. No manufacturer documents P25DE publicly. On mid-lock designs such as BorgWarner's unit for the Hyundai Gamma II, the pin only drops in when the rotor passes the slot under oil-driven cam torque, so a worn pin bore, debris in the phaser or a control valve that cannot reach its lock range are prime candidates. CARB names a pin failing to move to its position among the mechanical faults a VVT monitor has to catch. Symptoms: rough or noisy starts.
Possible causes
- Debris or wear in the phaser keeping the pin from dropping into its slot high
- Oil control valve sticking so the lock range of the spool is never reached medium
- Aged or contaminated oil slowing the phaser at hot idle medium
Symptoms
- Check engine lamp on
- Short rattle or knock from the timing drive right after starting
- Rough start or unsteady idle in the first seconds
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P25DE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.