P25DD
"A" Camshaft Position - Stuck In Locked Position (Bank 1)
Many modern cam phasers hold their rotor with a spring-loaded pin at a defined angle, often in mid travel, so the engine starts with stable valve timing before oil pressure builds. P25DD means the intake phaser on bank 1 is still latched at that angle although the controller has asked it to unlock and move, so variable timing is lost on that camshaft. Ford's 2014 code list for the Boss 302S engine carries P25DD as a lamp code next to P25E0, P25E3 and P25E6. BorgWarner describes a passive mid-position lock on Hyundai's Gamma II engine that is released purely by oil flow, which is why thin, dirty or low oil and a sticking control valve are the usual suspects. CARB requires faults that keep the phaser from reaching its target to be detected. Expect weaker pull and higher fuel use.
Possible causes
- Low oil level or pressure, or oil of the wrong viscosity, unable to push the pin out high
- Oil control valve for the bank 1 intake phaser sticking or its screen clogged medium
- Lock pin seized in its bore by sludge or wear inside the phaser medium
Symptoms
- Check engine lamp on
- Less pulling power, especially in the mid-speed range
- Higher fuel consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P25DD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.