P25DB
Fuel Level Sensor C Circuit Intermittent
P25DB describes short, repeated dropouts in the third fuel level input: the signal leaves its valid range for moments and returns, rather than staying low or high. Typical culprits are a loose pin, a wire that breaks contact only when the vehicle flexes or the tank moves, and a sender whose wiper briefly lifts off the resistor track over rough roads. No manufacturer documents P25DB publicly. Ford does not use a separate intermittent code for senders A and B; it catches short-term jumps through its noisy-signal check (more than 100 jumps of over 40 % at 0.1 s sampling) under the performance codes, which is the closest documented logic. Under CARB this input falls under mandatory supervision as well. The gauge may flicker or briefly fall to empty, and the fault can be hard to reproduce in the workshop.
Possible causes
- Loose or spread terminal in the sender C connector high
- Wire breaking contact when the frame or tank moves medium
- Sender wiper lifting off a worn resistor track medium
Symptoms
- Fuel gauge flickers or drops briefly to empty
- Check engine lamp may come and go
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P25DB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.