OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25DA

Fuel Level Sensor C Circuit High

P25DA is set when the third sender's signal climbs above the top of its valid range. On a resistor sender fed through a pull-up, that almost always means an open path: a broken wire, a disconnected plug, a burnt-out spot on the resistor track or a missing ground return. A short to a voltage source has the same effect. No manufacturer documents P25DA publicly. The sender A counterpart gives an idea of the limits used: Ford flags the high fault when resistance exceeds 200 ohms, corresponding to more than 253 A/D counts, for 30 s (P0463). CARB requires out-of-range monitoring for fuel level inputs. Unlike P25D9, the cause here is usually an interruption rather than a short, so connectors and the harness at the tank deserve the first look. The gauge will usually rest at one end.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / DA

Possible causes

  • Broken signal or ground wire to sender C high
  • Tank connector loose or unplugged after work on the tank medium
  • Interrupted resistor track inside sender C medium
  • Signal wire shorted to a voltage supply low

Symptoms

  • Gauge stuck at one end of the scale
  • Check engine lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P25DA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication