OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25D9

Fuel Level Sensor C Circuit Low

P25D9 reports that the signal of the third fuel level sender has dropped below its lowest valid value. With the usual resistor-type sender this points to very low resistance, typically a signal wire shorted to ground or a sender shorted internally. Whether low means empty or full depends on how the sender is wired, so the gauge may stick at either end. No manufacturer documents P25D9 publicly. For sender A, Ford uses a fixed limit as reference: below 5 ohms, which equals less than one A/D count, the low code is set after 30 s (P0462). CARB requires out-of-range checks on all fuel level inputs. Distinct from P25DA, the high fault, and from P25D7, which only states a general circuit problem. Expect a gauge pinned at one end and a stored lamp code.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / D9

Possible causes

  • Signal wire of sender C chafed and shorted to ground high
  • Internal short in sender C medium
  • Water in the tank connector bridging signal and ground low

Symptoms

  • Gauge pinned at full or empty
  • Check engine lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P25D9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication