OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25D7

Fuel Level Sensor C Circuit

Fuel level sensor C is a third level input, needed only where the fuel is spread over more chambers or tanks than two senders can cover, for instance on trucks with an extra tank. P25D7 is its general circuit code: the module sees an electrical fault on this input but does not classify it as low, high or intermittent. No manufacturer documents P25D7 publicly. The analogue at sender A shows how such a check works: Ford sets P0460 when the sender resistance stays below 5 ohms or above 200 ohms for 30 s. Regulators insist on supervising these inputs because misfire and evaporative tests may be suspended when the tank is at 15 % or less, and a wrong level can let them run or block them at the wrong time. For the driver the fuel gauge or range display may show nonsense or a substitute value.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / D7

Possible causes

  • Damaged wiring between tank C sender and module, often under the vehicle high
  • Corroded or loose connector at the sender medium
  • Sender C defective internally medium

Symptoms

  • Gauge or range wrong or replaced by a default value
  • Check engine lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P25D7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication