P25D5
Exhaust Camshaft Actuator Park Lock Control Circuit High (Bank 2)
P25D5 closes this series: the bank 2 exhaust phaser's lock control signal sits above its allowed voltage, pointing to a short to battery or ignition voltage, a return path tied to supply, or a defective output in the module. The protected driver then stops switching, and the lock solenoid stays without command until the next key cycle or until the fault vanishes. If P25D5 shows up together with high codes on other actuators, a shared harness fault or a module problem is more likely than a bad solenoid. There is no public manufacturer documentation for P25D5; the description draws on CARB's monitoring rules for variable valve timing and output components and on the design of locking phasers. Driveability suffers only mildly, but emissions and fuel use rise.
Possible causes
- Bank 2 exhaust lock wire shorted to battery or ignition voltage high
- Harness fault affecting several actuator lines medium
- Defective output in the engine control module low
Symptoms
- Check engine lamp on
- Slightly higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25D5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.