P25D4
Exhaust Camshaft Actuator Park Lock Control Circuit Low (Bank 2)
P25D4 reports a lock control line for the bank 2 exhaust phaser that is pulled down below its expected level. Grounding through damaged insulation, a solenoid with shorted turns or oil that has crept into the connector are the usual explanations. Because the exhaust manifold of the second bank radiates onto nearby harness sections, heat sleeving that has slipped out of place is worth checking. While the fault is active the controller cannot set the lock reliably and normally freezes exhaust timing on that bank. As with the other exhaust lock codes, there is no public manufacturer documentation; the account rests on CARB's circuit monitoring requirement and the operating principle of locking phasers. Repair is wiring work or a new solenoid.
Possible causes
- Heat sleeve slipped, wire grounded at the manifold high
- Shorted turns in the bank 2 exhaust lock solenoid medium
- Oil in the connector low
Symptoms
- Check engine lamp on
- Bank 2 exhaust timing fixed
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.